Adding ProVision BodyCams to the Server

1: Charge BodyCam and Dock the Camera on a Provision Dock

 

2: Go to https://10.99.21.30:5004/Device/BC4Registration and use new bodycam to scan the QR code.

Note: If the BodyCam says “Scanning QR Code” but will not scan or reset, follow the following steps:

  1. Dock the camera
  2. Press F1 and F2 at the same time to clear server URL
  3. Confirm with F1
  4. Let the device power cycle while on the dock
  5. Remove from the dock and it should say not set and you can scan the QR code again.

 

3. After the BodyCam has scanned the QR code from the server, dock the camera to contact the server.

4. After the camera has scanned the QR code successfully and you have docked the camera, check https://10.99.21.30:5004/Device/BC4Registration to assign the new camera to the server.

5. Check 10.99.21.30:5004 to find listed cameras. Make sure the new camera is listed and enabled.

6. The cameras save video to \\10.99.21.95\bodycam

Details

Article ID: 132904
Created
Wed 6/2/21 11:23 AM
Modified
Wed 6/9/21 2:35 PM